These matters must be noticed in the design of the soft and hard board!
- Release on:2019-01-15
These matters must be noticed in the design of the soft and hard board! The specific considerations include the following four aspects, which are described in detail below.
1. The pitch of the large-area grid of the soft and hard bonding board is too small. In the process of manufacturing the printed board, after the drawing process is completed, a lot of broken film will easily be attached to the board, causing disconnection.
2. The setting of the single-sided pad aperture of the soft and hard bonding board is not in place, and there will be problems when drilling.
3. The electrical ground layer of the soft and hard bonding board is also a problem of the flower pad and the connection. (Flexible PCB manufacturer china)
4. When the soft and hard bonding board is designed, the overlap of the pads, because the holes overlap, the drilling process may cause the hole to be broken due to multiple drilling in one hole.
If you want to know more information about PCBs，please click the link PCB Prototype supplier china
O-Leading Supply china CO., LTD
TEL: + 86-752-8457668
Fax: + 86-4008892163-239121+ 86-2028819702-239121
Email: [email protected]